Erro! Use a guia Página Inicial para aplicar Heading 1 ao texto que deverá
aparecer aqui. Erro! Use a guia Página Inicial para aplicar Heading 1 ao texto
que deverá aparecer aqui.
User’s Guide FlatpackS Rectifier & Supervision Modules, 11
Connection Drawing
Use this drawing as a customer connection reference for all cabling. You find the exact
location of connection terminals, plugs, DIP switches, jumpers, etc. by referring to chapter
“Location of Connector, Communication Ports” on page 11.
Connection Drawing for Smartpack S controller
The configurable inputs 1 through 4 operate in the range of max. – 10 to +10VDC, and
are intended for great accurate measurements, e.g. for temperature sensing using an
external temperature NTC probe. Also, these inputs are suitable for monitoring other
sensors (of pressure, humidity, etc.) that output 4mA to 20mA. An external 470 ohms
resistor is then to be connected to the input’s terminals on the controller, in parallel with
the sensor’s cables.
The configurable inputs 5 and 6 operate in the range of 0 to 75VDC, and are intended
for e.g. system voltage and battery symmetry measurements.
To Next Page
Loading...
