ELTEX NTU-2V - Ntu -Rg-1402 G-W; Reboot and Reset to Factory Settings; Delivery Package

____________________________________________________________________________________
____________________________________________________________________________________
22 NTU Optical Network Terminals
2.6.4 NTU -RG-1402G-W
The LED indicators located on the front panel show the current state of the device.
Table 16 provides possible statuses of the LEDs.
Table 16—Light Indication of Device Status
LED
LED Status
Device Status
LAN 1..4
green
established 10/100 Mbps connection
orange
established 1000 Mbps connection
flashes
transferring data packets
1..2
on
off-hook
flashes
port is not registered or SIP authentication is not completed
on server
flashes slowly
receiving a call
Wi-Fi 2.4/5
green
Wi-Fi network is inactive
flashes
transmitting data via Wi-Fi
off
Wi-Fi network is inactive
PON
off
device booting
green
authentication failed at optical line terminal
flashes green
authentication failed at optical line terminal
flashes red
no signal from optical line terminal
Status
off
WAN interface is in static or bridge mode, PPP client is not
running
green
device was successfully authenticated on line terminal (PPP
session started in WAN interface)
orange
device is not authenticated (PPP session is not started in
WAN interface)
Power
off
the device is disconnected from the power source or faulty
red
device booting
orange
the default configuration is active
green
current device configuration differs from the default one
2.6.5 Reboot and Reset to Factory Settings
To reboot the device press ‘Reset’ button once on the side panel (for NTU-2VC/NTU-2W, press ‘F’ button
located on the rear/back panel). To load the device with default factory settings, press the Reset (F) button and
hold it for 7–10 seconds until the POWER indicator turns red. The factory settings have the following IP
addresses: LAN—192.168.1.1, subnet mask—255.255.255.0. Access can be provided from LAN 1 and LAN 2
ports.
2.7 Delivery Package
The NTU-2V(C), NTU-2W, NTU-RG standard delivery package includes:
– NTU-2V, NTU-RG subscriber optical terminals;
– 220V/12V power adapter;
– Operation Manual.