ELTEX NTU-2V - Ntu-2 W

____________________________________________________________________________________
____________________________________________________________________________________
8 NTU Optical Network Terminals
 Firmware updates via web interface, TR-069, OMCI.
 Remote monitoring, configuration, and setup:
– TR-069;
– Web interface;
– OMCI;
– Telnet.
Fig. 1 shows a diagram of the NTU equipment connection.
Fig. 1—Connection of NTU-2VC
2.3.2 NTU-2W
The device has the following interfaces:
– 1 PON SC/APC port for connection to operator's network.
– Ethernet RJ-45 LAN ports for connection of network devices:
– 1 RJ-45 10/100 Base-T port;
– 1 RJ-45 10/100/1000Base-T port;
– 1 Wi-Fi transmitter/receiver 802.11b/g/n;
– 1 USB 2.0 port for external USB or HDD storages.
The terminal uses an external adapter for 220V/12V power supply.
The device supports the following functions:
– Network functions:
– bridge or router mode;
– PPPoE (PAP, CHAP, MSCHAP authentication);
– static IP address and DHCP (DHCP client on WAN side, DHCP server on LAN
side);
– UPNP;
– IPSec;
– NAT;
– Firewall;
– NTP;