____________________________________________________________________________________
____________________________________________________________________________________
NTU Optical Network Terminals 43
To add rules to the table, click the Add button. Click Remove in front of a selected rule to remove it.
– Use Interface— interface that is used.
Available are only the interfaces configured to work in the router mode with enabled translation of
network addresses.
– Application Name—application settings:
– Select an application—select a preconfigured rule;
– Custom an application—create custom rules not listed in the Select an Application list.
As opposed to the Virtual Server function, you don’t need to specify a fixed IP address of the computer in
LAN.
– Trigger Port Start—the first port of the port range to act as a trigger;
– Trigger Port End—the last port of the port range to act as a trigger;
– Trigger Protocol—the protocol used for the trigger;
– Open Port Start—the first port of the port range to be opened by the router;
– Open Port End—the last port of the port range to be opened by the router;
– Open Protocol—the protocol used for the opened ports.
Click the Apply/Save button to accept and save the changes.
To Next Page
Loading...
