ELTEX NTU-2V - Page 59

____________________________________________________________________________________
____________________________________________________________________________________
NTU Optical Network Terminals 59
– Band—frequency coverage
1
;
– Channel—select an operating channel for the router. Interference or any other issues of a wireless
network may be solved by changing the channel. The parameter is recommended to be set to Auto to
avoid interference caused by adjacent networks;
– Auto Channel Timer (min)—the time before the router searches for a better wireless channel. The
parameter is available when the Auto channel is selected (enter 0 to disable);
– Auto Channel Set—defines a channel autoselection mode:
– Full—autoselection scans all available channels to choose one;
– Legacy—autoselection scans a set of channels supported by old devices (for 2.4 GHz range only) to
choose one;
– Custom—austoselection scans channels from the list specified by user in the Allowed Channel
settings and chooses one.
– 802.11n/EWC—compatibility mode for 802.11n Draft2.0 and EWC (Enhanced Wireless Consortium)
equipment;
– Bandwidth—bandwidth of 20 GHz or 40 GHz. When set to 40 MHz, 2 adjacent bandwidths of 20 MHz are
used to broaden the channel's throughput;
– Control Sideband—select the second channel (Lower or Upper) in 40 MHz mode;
– 802.11n Rate—select connection rate;
1
NTU-RG-1402G-W models support 2.4GHz, NTU-RG-1402G-Wac models – 2.4/5GHz