Regulatory notices
Page 7
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
1.2.8 Important information for US customers
US CUSTOMERS ONLY: In the USA it is illegal for an end user to configure
their own AIS with their vessel data. To do so is a violation of the rules of the
United States Coast Guard (USCG). This must be done by a competent
installer, such as em-trak, an em-trak dealer or competent marine electronics
professional. If your transceiver has not been pre-configured for you please
refer to your dealer or contact support@em-trak.com for advice on how to
have the transceiver configured legally. If purchasing direct from em-trak
online we can configure it for you and dispatch it pre-configured at no extra
cost, if you are purchasing from one of our dealers, then they will do it for you.
1.2.9 Industry Canada notice
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
WARNING: It is a violation of the rules of the Federal
Communications Commission to input an MMSI that has not
been properly assigned to the end user, or to otherwise input
any inaccurate data in this device.
In the United States of America, the MMSI and static data must
only be entered by a competent installer. The end user of the
equipment is not authorised to enter their own vessel data.
To Next Page
Loading...
Need help?
General
