40
EMC Connectrix B Series DS-5300B Hardware Reference Manual
Operating the DS-5300B
Table 2 Nonport Side LED Patterns During Normal Operation
LED name LED color Status of hardware Recomended action
Power Supply
Status
No light Power supply is not receiving power
or is off.
Verify that the power supply is on and
seated and the power cord is connected to
a functioning power source.
Steady green Power supply is operating normally. No action required.
Steady amber (for
more than 5 seconds)
Power supply fault for one of the
following reasons:
Power supply is switched off
The power cable is disconnected
The power supply has failed
Note: When the switch is
first powered on the
power supply status
LED will show amber
until POST has
completed.
Try the following:
Check the power cable connection
Verify that the power supply is powered on
Replace the power supply FRU
Fan Status No light Fan assembly is not receiving
power.
Try the following:
Verify that the fan FRU is seated correctly
Verify that the switch is powered on
Steady green Fan assembly is operating normally. No action required.
Steady amber (for
more than 5 seconds)
Fan fault for one of the following
reasons:
One or more of the fan(s) in the fan
assembly has failed
The fan FRU was disabled by the
user
Note: When the switch is first
powered on the fan status LED will
show amber until POST has
completed.
Try the following:
Verify that the fan FRU is enabled (use the
fanEnable command)
Replace the fan FRU
To Next Page
Loading...