EMC VNX5500 - Page 21

Data Mover enclosure
EMC VNX5500 Parts Location Guide 21
4 303-122-100A Two-port 1-Gb/s copper plus
two-port 1G/bs optical I/O module
(for a closer view, see Figure 24 on
page 28)

5 100-562-718
100-563-228
I/O module filler includes Do Not
Remove label
Note: This filler panel is only used
when the Data Mover I/O module
slots are empty.

303-121-100A
1
Four-port 10/100/1000 Base-T
copper I/O module (for a closer
view, see Figure 21 on page 25)

303-081-103B
2
Two-port 10-Gb/s Ethernet Optical
I/O module (for a closer view, see
Figure 25 on page 29)

303-195-100B
3
Two-port 10-Gb/s Ethernet optical
or Twinax I/O module (for a closer
view, see Figure 29 on page 33)

303-164-104D-01
4
Two-port 10-Gb/s RJ-45 Base-T
iSCSI/IP (for a closer view, see
Figure 28 on page 32)

1. This part is not shown in the example Data Mover enclosure illustration in Figure 18 on page 20. For a closer
view, go to Figure 21 on page 25.
2. This part is not shown in the example Data Mover enclosure illustration in Figure 18 on page 20. For a closer
view, go to Figure 22 on page 26.
3. This part is not shown in the example Data Mover enclosure illustration in Figure 18 on page 20. For a closer
view, go to Figure 29 on page 33.
4. This part is not shown in the example Data Mover enclosure illustration in Figure 18 on page 20. For a closer
view, go to Figure 28 on page 32.
Table 11 Data Mover enclosure part numbers rear view (continued)
Part number label
location
(Figure 18) Part number Description FRU CRU