22 EMC VNX5500 Parts Location Guide
I/O modules
Management module
Figure 19 shows the part number label location on the rear view of the management
module used in the 2U Data Mover enclosure.
Figure 19 Example of the Data Mover enclosure management module
Table 12 shows the part number label location, part number, description, and whether it
is a FRU or CRU.
I/O modules
In the Block and File VNX5500 platform, I/O modules are used in the disk processor
enclosure (DPE) storage processors (SP A and B) and in the Data Movers of the Data Mover
enclosure.
Each I/O module is identified by a part number, type of ports (copper or optical), latch
handle label, and color label on top of the latch handle. For ease of identification,
Table 13 on page 23 describes each I/O module type in the VNX5500.
2
0
1
#
Part Number (P/N label
CNS-00168
Table 12 Data Mover enclosure management module part number
Part number label
location
(Figure 19 on
page 22) Part number Description FRU CRU
110-130-100B Management module
To Next Page
Loading...
