EMC VNX5500 - Standby Power Supply (SPS); Disk Processor Enclosure (DPE)

Standby power supply (SPS)
EMC VNX5500 Parts Location Guide 9
Standby power supply (SPS)
The Block and File VNX5500 platform can support up to two 1U standby power supplies or
dual (SPSs) to provide temporary emergency power to the Block and File VNX5500
platform. Part numbers for the SPS are only on the rear of the product.
Figure 4 shows the part number location of a dual 1U SPS.
Figure 4 Example of a dual SPS
Table 1 lists the part number label location, part number, description, and whether it is a
FRU or CRU.
Disk processor enclosure (DPE)
The 3U DPE has part numbers visible on both the front and rear.
Front view
The DPE has two types of disk drive carriers:
◆ 3U, 15 (3.5-inch) disk drives
◆ 3U, 25 (2.5-inch) disk drives
DPE 3U, 15 (3.5-inch) disk drive
Figure 5 on page 10 shows the front view of the DPE 3U, 15 (3.5-inch) disk drives.
Note: You can visually distinguish disk module kinds by their type, capacity, and speed
labels, and by the design of the latch and handle on each disk module (Figure 5 on
page 10).
900-XXX-0014 0082
A00REV
S/N
900-XXX-0014 0082
A00REV
S/N
Part Number (P/N) label
CNS-001545
Table 1 SPS part number
Part number label
location (Figure 4) Part number Description FRU CRU
078-000-084
078-000-085
DC standby power supply (SPS)
1200W
