EMC VNX5500 - How this Document Is Organized

How this document is organized
EMC VNX5500 Parts Location Guide 3
How this document is organized
The major sections of this guide are listed in the following table.
Related documentation
EMC provides the ability to create step-by-step planning, installation, and maintenance
instructions tailored to your environment. To create VNX customized documentation, go
to: https://mydocs.emc.com/VNX/.
To download a PDF copy of the desired publication, go to the following sections:
◆ For hardware-related books, go to the About VNX section, and then select Learn about
VNX. Next, follow the steps in the wizard.
◆ For technical specifications, go to the About VNX section, and then select View
technical specifications. Next, follow the steps in the wizard.
◆ For installation, adding, or replacing tasks, go to the VNX tasks section, and then
select the appropriate heading. For example, to download a PDF copy of the
VNX5500
Block Installation Guide
, go to Install VNX and follow the steps in the wizard.
Title Description
“VNX5500 Block and File
platform stackup” on page 4
Describes and shows the front and rear views of a typical
VNX5500.
“VNX5500 components” on
page 8
Provides a description of the components that comprise a
VNX5500. Along with a description, illustrations of each
component are also shown.
“Standby power supply (SPS)”
on page 9
Describes and illustrates the part number label locations of the
SPS.
“Disk processor enclosure
(DPE)” on page 9
Describes and illustrates the part number label locations of the
DPE and the components that comprise the DPE.
“Control Station” on page 16 Describes and illustrates the part number label locations of the
CS.
“Data Mover enclosure” on
page 17
Describes and illustrates the part number label locations of the
DME and the management module.
“I/O modules” on page 22 Describes and illustrates the part number label locations of the
I/O modules that comprise the DPE and the DME.
“Small form-factor pluggable
(SFP)” on page 34
Describes and illustrates the part number label locations of the
SFP transceiver modules used in the DME.
“DIMMs” on page 37 Describes and illustrates the part number label locations of the
memory module or dual-inline memory modules (DIMMs) used
in the DPE and the DME.
“Disk-array enclosure (DAE)” on
page 41
Describes and illustrates the part number label locations of the
three types of DAEs available for the VNX5500.