10 EMC VNXe3100/VNXe3150 — Replacing a Storage Processor
Tasks to replace an SP
Task 8: Replace the SP top cover
Replace the top cover on both the replacement and faulted SPs:
1. Align the cover tabs with the notches in the canister.
2. Slide it forward 1/4 inch until the tab secures the cover.
Task 9: Install the replacement SP assembly
1. Pull out the latches on each side of the replacement SP assembly and make sure they
stay in the open position.
2. Align the SP assembly with the chassis opening and push it straight into the chassis.
The latches begin to close when they contact the chassis edges.
3. Close the right and left latches to fully seat the SP assembly in the chassis.
An audible click indicates that the latches are secure.
4. Reconnect the cables to the back of the SP assembly being sure to connect all cables
to the same ports from which you removed them on the faulted SP.
The SP begins powering up immediately after connection to an active AC power
source.
2
1
CL4686
To Next Page
Loading...
