8 EMC VNXe3100/VNXe3150 — Replacing a Storage Processor
Tasks to replace an SP
Do not attempt to seat the I/O module into the CPU connector while you are holding
the I/O module at an angle. Doing so will damage the connections. The I/O module
should be flat before you attempt to seat the connector.
4. With the module aligned and parallel to the CPU board, press the latch down to fully
seat the module in the connector.
5. Push down on the force point indicated on the I/O module to ensure that the module
is completely seated on the processor board.
To Next Page
Loading...
