DPSI V-Match Operating Instructions Version 1.0
Page 6 of 16
2. Programming
There is no external programming device necessary, e.g. a PC or a
programming box for programming of the DPSI V-Match. Only a
delivered magnet serves for activation of the corresponding
programming functions. Everything else is conducted with the
transmitter and remote control equipment.
During programming, settings of the original servo (master = MSTR)
remain unchanged! Programming always refers to the slave servo
(SLAVE).
Hint:
Adjustment / programming of the slave servo is only possible within the first 10
seconds after power on. Afterwards, programming is inhibited for safety reasons!
Hint:
Before starting EACH programming, the corresponding transmitter stick (or
switch actuator) must be positioned in center position!
Hints:
If both servos MSTR and SLAVE actuate a common rudder, at least one
servo linkage must be released in order to avoid mechanical touch.
Hint:
Whenever a change e.g. of the servo center position takes place, the end-limits
should be reprogrammed as well!
Hint:
Basic adjustments in DPSI V-Match correspond to Graupner/JR equipment.
Center position is 1.50ms; end-limits are set to 100% each. Of course, all remote
control sets can be used with no limitation.
To Next Page
Loading...
