Emerson 3403 - Drive Enable; Electricity Cost Per Kwh; Reset Energy Meter; Run Time Log

Menu 6 Introduction
Parameter
x.00
Parameter
description format
Keypad and
display
Serial
communications
CT Modbus
RTU
PLC Ladder
programming
CTSoft Menu 0
Advanced parameter
descriptions
94 Commander SK Advanced User Guide
www.controltechniques.com Issue Number: 9
1: On Auto reset on enable disabled
If this parameter is set to On(1), the automatic reset on the toggle of the enable terminal of the drive is disabled.
0: OFF Drive disabled
1: On Drive enabled
Setting this parameter to OFF(0) will disable the drive. It must be at On(1) for the drive to run.
When this parameter is set up correctly for the local currency, Pr 6.26 will give an instantaneous read out of running cost.
If Pr 6.17 = On, the energy meter (Pr 6.24 and Pr 6.25) is reset and held at zero.
The run time log increments when the drive inverter is active to indicate the amount of time that the drive has been running since leaving the
manufacturing plant.
6.15 Drive enable
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
1 111
Range OFF(0) or On(1)
Default On(1)
Update rate 2 ms
6.16 Electricity cost per kWh
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
1 111
Range 0.0 to 600.0 Currency/kWh
Default 0.0
Update rate Background
6.17 Reset energy meter
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
111
Range OFF(0) or On(1)
Default OFF(0)
Update rate Background
6.18 to 6.21 Unused parameters
6.22 Run time log: years.days
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
31 1 1 11
Range 0.000 to 9.365 years.days
Update rate Background
6.23 Run time log: hours.minutes
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
21 1 1 11
Range 0.00 to 23.59 hours.minutes
Update rate Background
6.24 Energy meter: MWh
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
11 1 1 1
Range ±999.9 MWh
Update rate Background