Emerson Branson 2000IW+ - Figure 4.20 Connecting Tip to Horn; Table 4.9 Stud Torque Values; Table 4.10 Tip to Horn Torque Value

64 100-214-251 REV. 05
Stack Assembly Torque Tables
4.8.1 Connecting Tip to Horn
1. Clean the mating surfaces of the horn and tip. Remove foreign matter from the threaded stud
and hole
2. Hand assemble the tip to the horn. Assemble dry. Do not use any silicone grease
3. Use the spanner wrench and an open-end wrench (Refer to
Figure 4.20 Connecting Tip to Horn)
and tighten to the following torque tip specifications:
Figure 4.20Connecting Tip to Horn
NOTICE
The use of a Branson torque wrench or the equivalent is recommended. P/N 101-063-
617 for 20kHz systems.
Table 4.9 Stud Torque Values
Used On Stud Size Torque EDP#
20 kHz 3/8” x 24 x 1” 290 in lbs, 33 Nm 100-098-120
20 kHz 3/8” x 24 x 1-1/4” 290 in lbs, 33 Nm 100-098-121
20 kHz 1/2” x 20 x 1-1/4” 450 in.-lbs, 50.84 Nm 100-098-370
20 kHz 1/2” x 20 x 1-1/2” 450 in.-lbs, 50.84 Nm 100-098-123
Table 4.10 Tip to Horn Torque value
Tip Thread Torque
1/4 - 28 110 in.-lbs, 12.42 Nm.
3/8-24 180 in.-lbs, 20.33 Nm.
100-214-251 IWoper.book Page 64 Friday, June 16, 2017 4:12 PM