42 100-214-251 REV. 05
4. Cut the two packing straps around the base and pallet. Pry off the two wooden shipping blocks
(to the rear of the base) which prevent the base from sliding on the pallet
5. The stand can now be moved into its desired location by sliding it off the pallet. Stands have a
lifting hook for the use of overhead hoists to lift the assembly in place
6. Remove the block of wood between the base and the column support by carefully loosening the
two column clamps (allowing the actuator to rise slightly, but not allow sudden movements) and
then cutting the shipping tape on the block of wood. RETIGHTEN THE COLUMN CLAMPS
7. Unpack the toolkit from the insert box, and other parts (converter, booster, cables, manuals, etc.)
that may have shipped with the stand. Save the packing material
8. Go to
4.3 Take Inventory of Small Parts
4.2.2 Stand (2000IW/IW+ on a Hub)
Figure 4.2 Unpacking the Stand (2000IW/IW+ on a Hub); Hub shown separately
CAUTION General Warning
The column and column support are under spring tension from the
counterbalance spring. Do NOT attempt to disassemble the column
from the stand, but always keep the column
support clamped together. When making height adjustments,
carefully and slowly release the clamps to control the motion, and
hold the stand to prevent sudden movements or injury.
CAUTION General Warning
Heed the “This End Up” arrows and the “Open Top First” instructions.
The packaging is designed to be removed from the assemblies from
an upright orientation only.
Converter
Tool Kit
Booster
6-1/2in.
18in.
Shipping
Strap
53 in.
Block of wood
for shipping
32-1/2in.
Insert Box
Protective
Box
Hub
(shipped in place
on column, on pallet)
Two Hub Bolts
(loosen to remove
Hub from Column)
Note: Hubs may be lag-bolted to the
pallet for shipping purposes.
100-214-251 IWoper.book Page 42 Friday, June 16, 2017 4:12 PM
To Next Page
Loading...