60 100-214-251 REV. 05
4.6 Accessory Input/Output Option
This feature is available as an option, usually referred to as “Advance Features”. It allows
access to:
• Power Output
• Memory Output
• Seek Output
• Frequency Output
• Frequency Offset Input
• Power Supply Module Status Outputs
• Amplitude Output
• Amplitude Control Input
The kit (101-063-721) provides the necessary hardware and instructions to retrofit the
standard welder to utilize these features. The external cable provided (101-241-360) in
the kit is a 15 pin female to an open end. When the new rear mounting plate provided in
the kit is installed, this cable will plug into the male 15 pin connector mounted topmost on
this plate (refer to Figure 2.5 Rear Panel). The signals to the pinout are illustrated in the
following Figure.
Figure 4.16Accessory Input/Output Connector Pinout
100-214-251 IWoper.book Page 60 Friday, June 16, 2017 4:12 PM
To Next Page
Loading...