100-214-251 REV. 05 47
4.4.3 Electrical Input Power Ratings
Plug the Welder into a single-phase, grounded, 3-wire, 50 or 60 Hz power source. lists
the current and fuse ratings for the various models.
4.4.4 Factory Air
The factory compressed air supply must be “clean (to a 5 micron level), dry and
unlubricated” air with a regulated maximum pressure of 100 psig (690 kPa). Depending
on your application, the welder requires between 35 to 100 psi. Stands include an in-line
air filter. Welders on Stands require a customer-provided air filter. Use a lockout device on
the air line if required.
Ambient Operating Temperature +5° C to +50° C (41° F to 122° F)
Operating Altitude Up to 1000 m
IP Rating 2X
Table 4.3 Environmental Specifications
Environmental Concern Acceptable Range
Table 4.4 Input Power Requirements
1100 W 100V - 120V 13 Amp Max. @ 100V / 17 Amp CB NEMA 5-15P Plug
1100 W 200V - 240V 6.5 Amp Max. @ 200V / 8 Amp CB None supplied
2200 W 200V - 240V 14 Amp Max. @ 200V / 17 Amp CB None supplied
3300 W 200V - 240V 21 Amp Max. @ 200V / 20 Amp CB None supplied
CAUTION General Warning
Synthetic air compressor lubricants containing Silicone or WD-40 will
cause internal welder damage and failure due to the solvents
contained within these types of lubricants.
CAUTION General Warning
There should be no substitute for clean, dry air to run the welder. Use
of other types of gas could lead to premature degradation of seals.
Contact your Branson representative if you have any concerns.
100-214-251 IWoper.book Page 47 Friday, June 16, 2017 4:12 PM
To Next Page
Loading...