100-214-251 REV. 05 41
4.2 Handling and Unpacking
If there are any visible signs of damage to the shipping containers or the product, or you
later discover hidden damage, NOTIFY YOUR CARRIER IMMEDIATELY. Save the packing
material.
1. Unpack the 2000-series components as soon as they arrive. Refer to the following procedures
2. Verify you have all of the equipment ordered. Some components are packed inside other boxes
3. Inspect the controls, indicators, and surfaces for signs of damage
4. Save all packing material, including the pallets and wood spacer blocks
4.2.1 Unpack the Integrated Welder
The Integrated Welder is heavy (145 lbs.) and packed in a protective shipping container.
The actuator toolkit is packed with the welder. A booster, converter and other components
may be packed inside the shipping container (depending on the equipment ordered).
• Integrated Welders are shipped on a wooden pallet with a cardboard box cover over protective
foam shells for support
• Heed the “This End Up” arrows and the “Open Top First” instructions. The packaging is designed
to be removed from the assemblies from an upright orientation only
Figure 4.1 Unpacking the Stand (2000IW/IW+ on a Base); right-side view of Stand
1. Move the shipping container close to the intended installation location, leave it on the floor
2. Open the top of the box. Remove the insert from the top of the protective box, which may
contain the booster, converter, and the toolkit
3. Remove the staples at the bottom of the protective box. Lift the protective box off the pallet
6-1/2 in.
Tool Kit
Converter
Booster
18in.
Protective
Box
wood block
for shipping
53in.
32-1/2in.
Insert
Box
100-214-251 IWoper.book Page 41 Friday, June 16, 2017 4:12 PM
To Next Page
Loading...