Configure
Configure windowFigure 2-22:
The Configure window lets you configure device settings.
Important
To be able to edit configuration settings, select Current in the Time drop-down menu at the bottom of
the screen.
Guided Setup
Guided Setup lets you configure device settings in a guided step-by-step process.
Click Configure Sensors to display or configure installed sensors.
Click Configure Variable Mapping to display or specify which measurements are reported as
the Primary, Secondary, Third, and Fourth variables.
Click Configure Units to configure units for Overall Velocity, PeakVue, and temperature.
Click Alert Limits to define the lower range and upper range values and alert limits for
Advisory, Maintenance, and Failure for each of the process variables. You can also
configure alert reporting from here.
Click Sensor Power Enable to supply power to the sensor for a specific amount of time.
Configuration
MHM-97408, Rev 15 41
To Next Page
Loading...
