Note
Sensor Power Enable is only available when the device is connected to AMS Device Manager using a
USB or serial HART modem and when the device is connected to a Field Communicator. This feature
is not available when the device is connected to AMS Device Manager using a WirelessHART
connection.
Click Join Device to Network to enter network identifiers and join keys that will enable the
transmitter to join a wireless network.
Click Configure Publishing to set how parameters are published (generic or optimized).
Click Configure Update Rate to set how often the device acquires and reports new
measurements (update rate) and to specify the number of times the transmitter skips data
acquisitions between updates to the gateway (PowerSave Skip Multiplier).
Manual Setup
Manual Setup lets you configure device settings manually.
Click the Wireless tab to display wireless network information for the transmitter.
Wireless tabFigure 2-23:
Click Join Device to Network to enter network identifiers and join keys that will enable the
transmitter to join a wireless network.
Click Configure Publishing to set how parameters are published (generic or optimized).
Configuration
42 MHM-97408, Rev 15
To Next Page
Loading...
Need help?
General
