Emerson Epsilon Eb Series - Page 181

164
Epsilon Eb and E Series EN Drives Reference Manual
E Series Only
E
N
According to UL requirements, the E Series drive is suitable for use on a circuit capable
of delivering not more than 5000 RMS symmetrical amperes, 240 volts maximum.
Figure 100: E Series AC Power Wiring Diagram
Figure 101: Epsilon AC Power Wiring Diagram
Caution
Do not connect or disconnect AC power by inserting or removing the AC power
connector. Using the connector in this manner, even once, will damage the connector
making it unusable.
Top View
L1 L2 L3 PE
Wire crimp ferrules are recommended:
If 14 AWG, use panduit #PV14-P47.
If 12 AWG, use Panduit #PV10-P55.
50/60 Hz
90-264 VAC
Note: L3 is used with the E N -214 only.
When cycling power make sure AC power is
off for 5 seconds minimum before reapplying
power.
L1
Tighten screws
to 5 lb-in.
L2
L3
GND
J1
L2
Front View
50/60 Hz
90-264 VAC
Tighten screws
to 5 lb-in.
L1
GND
J1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com