171
Installation
Figure 107: Motor Feedback Connector Pinout
Motor Brake Wiring
Motors equipped with brakes have a three-pin MS style connector. The EMERSON Motion
Control brake power cable (model CBMS-XXX) has an MS style connector on the motor end
and three wire leads on the amplifier end (see the following wiring diagrams).
You must provide a DC power supply rated at +24 VDC with a 2 amp minimum current
capacity for the brake. If you use this voltage source to power other accessories such as I/O
or more than one brake, you must increase its current capability.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
