Emerson Epsilon Eb Series - Page 192

175
Installation
E Series Only
E
N
The I/O connector is a 10-pin removable terminal block. It is recommended that #18 to 24
AWG stranded wire be used.
Epsilon Only
The I/O connector is a 26-pin male connector on the front of the drive. EMERSON
Motion Control offers a low profile interface plug (STI-EIO) and cable (EIO-xxx) for
connections.
Figure 114: E Series I/O Connector to Command Connector Internal Connections
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com