Options and Accessories 53
Safety Information Product Overview Installation Diagnostics
Options and
Accessories
Specification
STI-ENC
The STI-ENC interface board allows the user access to the encoder feedback connector (J6) on the EP drive. The
STI-ENC plugs directly in J6 on the bottom of the drive. The numbers printed on the connector label correlate to the
screw terminal numbers.
Shield connection points are connected from the shell of the "D" connector to the faston lug connector.
Figure 50: STI-ENC Drive Encoder Feedback Board
Do not allow ESD directly to terminals. Always discharge static electricity to enclosure, not the drive when
performing maintenance.
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15
To Next Page
Loading...
