Use type with the mark in this unit.
Recording/Playback Time of Video Tape
Video cassettes are equipped with a safety tab to prevent accidental erasure. When the tab is removed,
recording can not be performed. If you wish to record on a cassette whose tab has already been removed,
use adhesive tape to block the hole.
When viewing a video cassette or a channel selected on the VCR, the picture and sound are sent to the TV
through an unused channel (either 3 or 4). The 3/4 channel selector switch on the VCR must be set to the
same channel as the TV set.
VIDEO CASSETTE (CONTINUED)
TYPES OF VIDEO CASSETTE
TO PREVENT ACCIDENTAL ERASURE
17
Type SP Mode EP Mode
(Standard Play) (Extended Play)
T-60 1 hour 3 hours
T-90 1 hour 30 min. 4 hours 30 min.
T-120 2 hours 6 hours
T-160 2 hours 40 min. 8 hours
• To prevent accidental erasure
•After recording, break off the safety tab with a
screwdriver if you don't want to record over
the tape.
• To record again
•Cover the hole with cellophane tape.
SETTING THE VIDEO CHANNEL
Set the 3/4 channel selector switch on the rear
of the unit to the vacant channel in your area
(3 or 4).
1
Set the TV's channel to correspond with the channel selected on
the VCR's 3/4 channel selector switch.
2
To Next Page
Loading...
