Emerson Fisher 4211 - Typical Transmitter Mounting on Type 1250 or 1250 R Actuator

4200 Series Transmitters
Instruction Manual
Form 5596
November 2006
33
APPLY LUBRICANT
40B7441−A / DOC
Figure 18. Typical Transmitter Mounting on Type 1250 or 1250R Actuator
Key Description Part Number
Parts for Mounting the Transmitter on
Type 1250 or 1250R Actuator (figure 18)
21 Mounting Plate, steel 49A7856X012
25 Operating Arm, zn pl steel 19A3811X012
26 Cap Screw, pl steel 1H3284X0012
27 Square Nut, pl steel 16A6711X022
29 Torsional Spring, zn pl steel 19A3812X012
30A Lever/Bearing Assembly, steel 18A0645X012
30B Transfer Pin, stainless steel 16A6707X012
30C Pickup Pin, stainless steel 16A6701X012
31 Shoulder Screw, stainless steel 10B5722X012
32 Hex Cap Screw, pl steel (2 req’d) 1C631224052
Key Description Part Number
33 Stem Bracket, steel
Size 225, 450 30B6736X012
Size 675 30B7385X012
36 Sleeve, acetal 16A0428X012
49 Thread Locking Adhesive (medium strength)
(not furnished with transmitter)
51 Thread Locking Adhesive (mild strength)
(not furnished with transmitter)
91 Cap Screw, pl steel (2 req’d)
w/positioner 10B6606X012
w/o positioner 10B6605X012
92 Washer, pl steel (2 req’d) 10B6609X012
93 U-Bolt, pl steel (2 req’d) 19A7930X012
94 Hex Nut, pl steel (4 req’d) 19A4838X022
95 Washer, pl steel (4 req’d) 10B6610X012