Index
September 2013
Index-5
Principle of Operation
DVC6000, A-2
HART Communication, A-2
Printed Wiring Board Assembly
Parts List, 8-5
Removing, 7-6
Replacing, 7-7
Setting DIP Switch, 7-7
Protection, 3-2, 4-3
PST Press Limit, double acting actuators,
4-20
R
Raw Travel Input, Displaying Status, 6-8
Related Documents, 1-3
Relay
Double−Acting, 5-10
Single−Acting Direct, 5-11
Single−Acting Reverse, 5-11
Relay A, 5-10
Relay Adjustment, 5-10
Double−Acting, 5-10
Relay B, 5-11
Relay C, 5-11
Relay Type, 4-18
Remote Travel Sensor Connections, 2-25
Using a 10 kOhm External Potentiometer
as, 2-25
Using a Two−Resistor Series as, 2-27
Using the DVC6015, DVC6025 and
DVC6035 Feedback unit as, 2-25
reset, 4-8
Restart Control Mode, 4-3
Revision Information, DVC6000
Device, 6-8
Firmware, 6-8
Hardware, 6-8
HART Universal, 6-8
S
Serial Number
Instrument, 4-17
Valve, 4-17, 4-18
Service Tools, 6-2
Set Point Filter Time, 4-11
Set Point Rate Close, 4-11
Set Point Rate Open, 4-11
Setpoint, 6-7
Setup Wizard, 3-2
SIS, Pressure Mode Enable, 4-10
SIS Alerts, 4-15
Solenoid Valve Testing, 2-22
special application, 2-22
Special Instructions for Safe Use and
Installations in Hazardous Locations, 2-4
ATEX Flameproof, 2-5
ATEX Intrinsic Safety, 2-4
ATEX Type n, 2-5
CSA, 2-4
FM, 2-4
IECEx Intrinsic Safety, Type n, Flameproof,
2-5
Specifications, 1-3
Stabilize/Optimize, 3-4, 4-6
Status, 4-16, 6-4
Calibration & Diagnostics, 4-17
Instrument Time, 4-16
Integrator, 4-17
Integrator Saturation, 4-17
Operational, 4-17
Steady−State Air Consumption, 1-5
Stroke Valve, 6-4
Stroking the Output, with Field Communicator,
6-4
Supply Pressure, 1-5
Displaying Value, 6-7
T
Temperature
Maximum Recorded, Displaying Value, 6-7
Minimum Recorded, Displaying Value, 6-7
Units, 4-17
Terminal Box
Parts List, 8-4
Removing, 7-8
Replacing, 7-8
TEST Terminals, 7-15
Third−Party Approvals, 2-4
Touch−Up Travel Calibration, 5-6
Index
G
To Next Page
Loading...
