Emerson MICRO MOTION 2700 - 3.2 Default values and ranges; 3.3 Enable access to the off-line menu of the display; 3.4 Disable write-protection on the transmitter configuration

3.4 Rotate the user interface on the transmitter
(optional)
The user interface on the transmitter electronics module can be rotated 90º or 180° from
the original position.
Display componentsFigure 3-9:
A
B
C
G
E
F
D
A. Transmitter housing
B. Sub-bezel
C. Display module
D. Display screws
E. End-cap clamp
F. Cap screw
G. Display cover
Procedure
1. Shut off power to the unit.
2. Remove the end-cap clamp by removing the cap screw.
3. Turn the display cover counterclockwise to remove it from the main enclosure.
4. Carefully loosen (and remove if necessary) the semicaptive display screws while
holding the display module in place.
5. Carefully pull the display module out of the main enclosure until the sub-bezel pin
terminals are disengaged from the display module.
Note
If the display pins come out of the board stack with the display module, remove the pins and
reinstall them.
6. Rotate the display module to the desired position.
Mounting and sensor wiring for 4-wire remote installations
Installation Manual 25