C. How to Set Multiflex Input point for MRLDS - 250
1. An input point on a Multiflex board consists of two terminals. One of these terminals,
labeled as “SIG” reads the signal from the sensor, while the other, labeled “0v” is where
the sensor’s ground wire is connected.
2. The Analog Output Signal (+) should go to (SIG) terminal of the Multiflex board and the
Ground (GND) should go to (0v) terminal of the board.
3. The Dip Switch setting of the Multiflex board for the MRLDS – 250 should be in OFF
position since it supplies its own voltage signal to the point.
To Next Page
Loading...
