Figure 2-11: Sink four-wire
A. Detector
B. Controller
C. Input power: 18 to 32 VDC
D. Return
E. 0-20 mA meter
Figure 2-12: Source three-wire
A. Detector
B. Controller
C. Input power: 18-32 VDC
D. Return
E. 0-20 mA meter
Note
For additional configuration options, please refer to the Flame Detectors.
3. Check the wires for secure mechanical connection and press them neatly against the
terminal to prevent them from interfering while closing the back cover.
4. Close the terminal compartment by screwing the back cover on to the housing.
Installation Manual
September2023 00809-1400-4975
20 Emerson.com
To Next Page
Loading...
