Document Part # 026-4144 Rev 8 Page 3 of 10
©2018 Emerson Climate Technologies Retail Solutions, Inc. This document may be photocopied for personal use.
Visit our website at http://www.emerson.com for the latest technical documentation and updates.
5. Click Use the following IP address: and enter the IP address 192.168.1.251 and the Subnet mask 255.255.255.0 of the PC being used on
the Local Area Network or direct connection and click OK:
Logging Into the Site Supervisor Controller
1. Launch a preferred Web browser: IE 9 and above, Firefox 13 and above, Chrome (all versions), and Safari (all versions) are the supported
browsers.
2. Enter the IP Address of the device.
3. Enter your Username/Password (default user/pass) and click Login. Then update your password to the minimum complexity
requirements and click Save.
Note that when directly connecting your laptop or PC to ETH1, enter the default IP into the browser address bar: ETH1 Default IP Address is
192.168.1.250.
Figure 6 - IP Address and Subnet Mask
Figure 7 - Login Screen at Controller Startup and Update Password
To Next Page
Loading...
Need help?
General
