Emerson SP1201 - Drive Features

Safety
Information
Introduction
Product
information
System
design
Mechanical
installation
Electrical
installation
Getting
started
Optimisation Parameters
Technical
data
Component
sizing
Diagnostics
Unidrive SP Regen Installation Guide 17
Issue Number: 2 www.controltechniques.com
3.4 Drive features
Figure 3-2 Features of the drive sizes 1 to 6
1
2
Solutions Module
slot 2
SMARTCARD
slot
Keypad
connection
Serial port
connector
Control terminals
Solutions Module
slot 1
Solutions Module
slot 3
Rating label
Status LED
Approvals label
Relay terminals
± DC Bus output
(High current)
EMC
capacitor
must be
removed
3
4
AC supply
(U, V, W)
EMC capacitor
must be
removed
5
EMC capacitor
must be
removed
± DC Bus output
(High current)
AC supply
(U, V, W)
6
EMC capacitor
must be
removed
± DC Bus output
(High current)
A
C supply
(U, V, W)
±
DC Bus output
(High current)
EMC
capacitor
must be
removed
AC supply
(U, V, W)
± DC Bus output
(High current)
EMC
capacito
r
must be
removed
3
Charging input
(L1, L2, L3)
A
C supply
(U, V, W)
Charging input
(L1, L2, L3)
AC supply
(U, V, W)
Charging input
(L1, L2, L3)
Charging input
(L1, L2, L3)
± DC Bus output
(High current)
Charging input
(L1, L2, L3)
Charging input
(L1, L2, L3)