Unidrive M / HS Frame 7 to 10 Power Installation Guide 7
Issue Number: 5
Person authorised to complete the technical file:
P Knight
Conformity Engineer
Newtown, Powys, UK
IMPORTANT NOTICE
These electronic drive products are intended to be used with appropriate motors, controllers, electrical
protection components and other equipment to form complete end products or systems. Compliance with
safety and EMC regulations depends upon installing and configuring drives correctly, including using the
specified input filters.
The drives must be installed only by professional installers who are familiar with requirements for safety
and EMC. Refer to the Product Documentation. An EMC data sheet is available giving detailed information.
The assembler is responsible for ensuring that the end product or system complies with all the relevant
laws in the country where it is to be used.
G. Williams
Vice President, Technology
Date: 17th March 2016
Place: Newtown, Powys, UK
Unidrive M frame7 to 10 Power Installation Guide issue5.book Page 7 Tuesday, May 24, 2016 11:52 AM
To Next Page
Loading...
Need help?
General
