Emerson Unidrive M700 - Page 95

SI-Ethernet User Guide 95
Issue: 1
Safety
information
Introduction
Mechanical
installation
Electrical
installation
Getting started Parameters
Key features
and Protocols
PC Applications Security Diagnostics
Glossary of
terms
Index
Defines the event to trigger in the specified destination (RPI timeout event destination
(S.20.012)) upon an RPI timeout.
This parameter defines the action to be taken upon a PLC idle event.
S.20.013 RPI timeout event type
Minimum 0 Maximum 5
Default 0 Units
Type 8 Bit User Save Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/
IP interface enable
Display Format None Decimal Places 0
Coding RW, TE, BU
Value Text Description
0 No event No event
1 Trigger Event Trigger module Event
2 Trigger Event 1 Trigger module Event 1
3 Trigger Event 2 Trigger module Event 2
4 Trigger Event 3 Trigger module Event 3
5 Trigger Event 4 Trigger module Event 4
This feature is not yet implemented.
S.20.015 PLC idle action
Minimum 0 Maximum 4
Default 4 Units
Type 8 Bit User Save Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/
IP interface enable
Display Format None Decimal Places 0
Coding RW, TE, BU
Value Text Description
0 Trip Trip drive with Slx.Er and sub-trip code
1 Send flt values Send configured fault values to the output parameters
2 Clear output
PLC output parameters will have their values set to
zero
3 Hold last Hold the last value in output parameters
4 No Action No action with output parameters
NOTE