EMI S1CG - Pre-Installation Safety Procedures; Read Before Proceeding Instructions; Critical Safety Warnings and Precautions

S1CG/S1HG
S
in
g
le-Zone, S2CG/S2H
G
Dual-Zone
•
I
nstallation,
Op
eration and Maintenance Manual •
P/N 240007754, Rev. C [3/19/2010] 3 Made in the USA
Read Before Proceeding
Recognize this symbol as an indication of
important safety information.
WARNING
Completely read all instructions
prior to assembling, installing, oper-
ating, or repairing this product.
Inspect all parts for damage prior to
installation and start-up.  e EMI series
high e ciency condensing unit must be
installed ONLY by quali ed installation
personnel.
Safety Instructions
 is manual is intended as an aid to quali-
 ed service personnel for proper installa-
tion, operation, and maintenance of the
EMI series high efficiency condensing
unit. Read these instructions thoroughly
and carefully before a empting installa-
tion or operation. Failure to follow these
instructions may result in improper instal-
lation, operation, service, or maintenance,
possibly resulting in  re, electrical shock,
property damage, personal injury, or
death.
Read all instructions before using this
unit. Install or locate this unit only in ac-
cordance with these instructions. Use this
unit only for its intended use as described
in this manual.
Check the rating plate on the unit before
installation to make certain the voltage
shown is the same as the electric supply to
the unit.  e rating plate is located on the
front panel only.
This unit must be connected only to a
properly grounded electrical supply. Do
not fail to properly ground this unit.
Turn o the electrical supply before servic-
ing the unit.
Do not use the unit if it has damaged wir-
ing, is not working properly, or has been
damaged or dropped.
DANGER
Tampering with this unit is danger-
ous
. Tampering voids all warranties. DO
NOT
a empt to modify or change this
unit in any way.
DANGER
 e EMI series must:
Be connected to a properly grounded •
electrical supply with the proper
voltage as stated on the rating plate.
Have proper over current protection •
(i.e. time-delay fuse/HACR Breaker)
as listed on the rating plate.
Failure to follow these instructions can
result in a  re, explosion, or electrical
shock causing property damage, personal
injury, or death.