EasyManua.ls Logo

EMI S1CG - Unit Verification and Components; Verify Unit Before Installation; Product Description and Key Features; Factory Controls and Components Identification

Default Icon
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
S1CG/S1HG
S
in
g
le-Zone,
S2CG/S2H
G
Dual-Zone
•
I
nstallation,
Op
eration and Maintenance Manual •
Comfort where it counts 4 P/N 240007754, Rev. C [3/19/2010]
Product description
e EMI Series S1CG/S1HG and S2CG/
S2HG condensing units are air-cooled, verti-
cally-arranged side-discharge, high-e ciency
units designed speci cally to meet or exceed
a 13 SEER rating.
e S1CG Models 09–36 and S1HG Models
09–24 condensing units will provide cooling
and heating for a single air handler, as identi-
ed on page 34 and page 35 .
e S2CG/S2HG 18,000 (99), 21,000 (92)
and 24,000 (22) Btuh capacity condensing
units will provide cooling and heating for two
air handlers, as identi ed on page 36 .
The S1CG/S1HG and S2CG/S2HG are
quiet units that can be recommended for both
commercial and residential applications.
Features
Installation of the S1CG/S1HG and •
S2CG/S2HG condensing units is sim-
pli ed by a 24v control interconnection
from the air handler.
Multiple units can be lined up in close •
proximity to an exterior wall.
Service valves are recessed to reduce •
tampering.
All 9,000-12,000 Btuh units are equipped •
with a Duratec Performance Package that
includes an oversized suction accumula-
tor with surge ba es and enhanced oil
management and a factory-installed solid
core  lter drier.
A factory-installed crankcase heater is •
standard on S1HG 09 &12 (thermostati-
cally controlled) and S2HG models, and
is available as optional equipment on
other models.
Verify unit before installing
Controls and components
(Factory-installed or supplied)
Compressor and fan motor contactor•
Run capacitor•
Low voltage terminal connections•
H.P.S. (High pressure switch) with •
manual external reset
Heat pump hard start•
Cooling operation down to 32°F standard •
on all units
Models 09–12 only:•
Large capacity suction accumulator –
Solid-core  lter drier –
Thermostatically-controlled crank- –
case heater (heat pump only)
Thermostatically-controlled
crankcase heater
This feature energizes the crankcase •
heater only when needed, saving unnec-
essary power usage and increasing overall
system e ciency.