6.2.9 Technician Password
63
It is used for accessing to the technician parameters.
It can be adjusted from 0 to 9999.
If it is ; there is no password protection while entering to the
technician parameters.
If it is different from “ 0” and user wants to access to the
technician parameters;
1- If technician does not enter password correctly:
It turns to operation screen without entering to operator parameters.
2- When in top display and in bottom display is observed,
if technician presses SET button without entering password
(For observing parameter)
Technician can see all menus and parameters except Technician
Password menu (“Pass Conf”), but parameters can not be changed.
( Please refer to Section 7. Failure Messages (4) in ESM-7730 Process
Controllers )
To Next Page
Loading...
