Emmaljunga SENTO - Assembly of the Apron (Accessories); Assembly of the Seat Unit Fabric; Insect Net (Delivery with Chassis); Raincover (Accessories)

51
SENTO, SENTO PRO Carrycot+, ERGO+, FLAT+ v. 2.0
SE
SE
2-13
133-155
NO
2-13
110-132
FI
2-13
87-110
DK
2-13
60-86
DE
2-13
37-59
EN
2-13
14-36
SE
SE
2-13
276-301
PL
2-13
252-275
LV
2-13
228-251
LT
2-13
203-227
ES
2-13
179-202
EE
2-13
156-178
CZ
6.4 Thread all seat belts through the
holes.
6.5 Remove the push button around the
folding handle and remove the fabric
from the seat frame.
FLAT
6.1 Press the buttons on both sides of the
hood and remove the hood from the
seat unit.
6.2 Open the press studs on the seat unit
and on the footrest.
6.3 Thread the harness straps through the
holes in the fabric.
6.4 Thread the crotch strap from the
fabric and remove the fabric from the
seat unit.
7) Assembly of the seat unit fabric
ERGO
See point 1) Montera Seat unit Assembly
of the seat unit
FLAT
7.1 Place the seat unit fabric in the seat
unit. Thread the shoulder straps
through the fabric.
7.2 Thread the crotch strap through the
seat fabric.
7.3 Thread the waist straps through the
seat unit fabric.
7.4 Fasten all of the press studs on the
seat unit.
7.5 There are a total of 13 press studs. 5
press studs on each side and 3 on the
back.
7.6 Attach the crotch strap by positioning
it around the bumper bar and secure
it by fastening the press stud.
7.7 Attach the hood into the frame
7.8 Attach the hood in place using the
velcro strips attached to the seat unit
fabric.
WARNING
• Never use the pram without making
sure the seat unit fabric is correctly
assembled on the frame rst.
• The hood should always be assembled
when the stroller is in use.
8) Insect Net (delivery with chassis)
ERGO & FLAT
8.1 Attach the Insect net using the zipper
on the hood. Pull the elasticated band
of the insect net completely over the
footrest.
8.2 Use the press stud to secure the
elasticated band of the insect net
onto the seat unit. Repeat on the
other side.
FLAT
8.3 Storage pocket for the Insect Net.
9) Assembly of the apron
(accessories)
1. Pull the apron over the footrest.
2. Fasten the apron with the press studs
on the inside of the hood and on the
seat frame.
3. Open the zip in the middle of the
apron when taking your child in or out
of the pram.
IMPORTANT! The hood cannot be
folded down when the apron is attached
to the hood.
10) Raincover (accessories)
10.1 Assemble the rain cover by placing it
over the hood and the carrycot or the
seat unit.
10.2 The rain cover has a large window at
the top opening that you can open
and close with the Velcro fasteners.
10.3 Make sure that the side ventilation
windows are always open and free
so that ventilation is ensured. Always
use rain protection when it is raining
or snowing. If the stroller is wet, try to
dry it rst before using the rain cover.
Let the rain cover dry properly before
putting it back in its pocket.