Emmaljunga SENTO - Page 55

55
SENTO, SENTO PRO Carrycot+, ERGO+, FLAT+ v. 2.0
SE
SE
2-13
133-155
NO
2-13
110-132
FI
2-13
87-110
DK
2-13
60-86
DE
2-13
37-59
EN
2-13
14-36
SE
SE
2-13
276-301
PL
2-13
252-275
LV
2-13
228-251
LT
2-13
203-227
ES
2-13
179-202
EE
2-13
156-178
CZ
NO WARRANTY IS GIVEN���
No warranty is given for defects or
damage to the product for which we are
not responsible. This applies in particular
to
• natural signs of wear and tear and
damage caused by
excessive use
• Consequential defects that have arisen
because damage/defects have not
been taken into account and therefore
lead to more difcult repairs.
• Damage caused by unsuitable or
improper use (see instructions for use).
• Damage caused by incorrect assembly
or commissioning.
• Damage due to negligent handling or
lack of maintenance of the purchased
item
• Damage caused by improper
modications to the purchased item.
WARRANTY CASE OR NOT?
Rust: The frame is treated against rust to
provide proper basic protection. However,
rust spots may occur if maintenance is
not carried out. No guarantee is given for
this.
Scratches: Scratches are normal signs of
wear and tear and are not covered by the
warranty.
Mould growth: If textile parts have
become damp, they must be dried
properly to prevent mould growth.
No guarantee can be given for mould
growth.
Bleaching of the fabrics: We
conrm that the fabrics comply with
the applicable standards. Sunlight,
perspiration, cleaning agents, abrasion
(especially in the grip area) or too
frequent washing cannot rule out
fading and are therefore not grounds
for complaint. Unfortunately, slight
differences in colour between individual
production batches cannot always be
avoided. No guarantee can be given for
this.
Tearing of the seams/press studs/
fabric: Please check carefully when
purchasing that all fabric parts, seams
and press studs are properly sewn and
fastened. Any complaints about seams/
defective press studs must be reported to
your specialist dealer as soon as the fault
is discovered.
Wheels: pushchair wheels are not
balanced and may therefore exhibit a
slight radial run-out (‘wobble’). Worn
wheels are a natural sign of wear. Flat
tyres on pneumatic wheels can only be
caused by external inuences, sharp
objects or driving with insufcient air
pressure. No warranty can be accepted
for this.
For pneumatic tyres: Please note
the information on air pressure under
different conditions (heat, cold, transport
when travelling by air. No warranty can be
given for damage caused by excessive air
pressure.
Push handle: Abrasion in the handle
area can be caused by friction, cleaning
agents, sun cream or other external
inuences. These are natural signs of wear
and tear for which no guarantee can be
given. The push handles can be easily
replaced. The replacement of wearing
parts is subject to a charge.
In snowfall and temperatures around zero
with damp, sticky snow, snow may freeze
to the wheels and create a snowball
effect. This is particularly the case if the
vehicle is brought into the cold directly
from the heat. This is not a reason for
complaint. To prevent water/moisture
from freezing to the tyres, you can use
general wax sprays or anti-freeze wax
sprays for skis in such cases.
What you should consider when buying
Check that the stroller has been delivered
complete and that no parts are missing.
Check that all the functions of the stroller
are working properly and conrm this on
the handover report.
Procedure for complaints
Report the fault immediately to the
Emmaljunga partner/dealer where you
ordered/purchased the pushchair in order
to discuss how to proceed. No warranty
can be given for safety-related defects
that are not reported to the dealer
immediately after they occur. Product-
specic depreciation rates may apply
when processing claims.