ENEN
42
8.3 Screen 4.1 HEAT PUMP
Pressing the icon accesses the screen
4.1 HEAT PUMP, which can be divided into three parts.
1) HP Widget, read-only, where information relative to the HP
status is displayed:
External temperature
Water flow rate
Water temperature
in the HP output
Water temperature
in the HP input
Electrical power
absorbed
Thermal power rendered in cooling
In heating
Temperature of water leaving
the HP in cooling
In heating
Water inlet temp to HP in
cooling
In heating
8. GUEST SCREENS
Minimum water tempera-
ture for the radiant
in cooling
Water temperature for compressor
modulation
Current Target
Compressor step
0÷10
Defrosting
Photovoltaic
tracking
MIRAI SMI
in production
DHW
Additional
heater
Frost pro-
tection
Coloured ions if the function is active
2) A read-only part, which displays the information related to the
operation of the HP:
NOTA:
Only on some Recipes (e.g., Recipe 12) is an additional temperature
sensor installed, positioned on the water supply pipe to the radiant
system.
Current water temperature at the radiant inlet
in heating
in cooling
GUEST
To Next Page
Loading...
Need help?
General