NAVIGATING THROUGH SETTINGS
Once in Settings Mode, use the trigger is used to navigate to the next setting, where
the LED indicates which setting as listed in the chart above. Pressing and releasing
the trigger quickly will navigate to the next setting. The LED color/status will change
accordingly.
Example: If currently in Firing Mode (solid Red), press and release the trigger 3 times
to get to De-Bounce (ashing Red).
LED Setting
Solid Red Firing Mode
Solid Green Max ROF
Solid Amber Dwell
Flashing Red De-Bounce
Flashing Green Ball In Place
Flashing Amber Ramp Start
Fast Flashing Red Ramp Sustain
CHANGING SETTINGS
To change a setting, first navigate to the setting you would like to change by using
the trigger as described above. Once at the desired function, press and hold the trig-
ger for 2 seconds. The LED will then begin blinking to indicate the setting’s current
value. Once the blinking stops, the LED will turn off and you have a 3 second window
to begin entering a new value. Press and release the trigger the number of times
corresponding to the desired new setting value. After the desired number is reached,
release the trigger and after 3 seconds the LED will cycle through an array of colors to
indicate the setting is saved. If you do not enter any trigger pulls to modify a setting,
the value remains the same. If you enter more than maximum amount of trigger pulls
for any setting, the value will become the maximum value for that setting.
Power off the marker to exit the Settings Mode. Any setting that was modified will be
stored and ready to use upon startup.
FIRING MODES
-WILL BE INDICATED BY SOLID RED LED
You must be in the Settings Mode to change Firing Modes, see above for instructions
on how to enter Settings Mode. After choosing Firing Modes (Solid Red), hold the
Trigger, the LED will flash Red LED blinks equal to the current setting, followed by
a pause. Pull the trigger the number of times equal to your new desired setting (see
chart below). Once done, the LED will cycle through an array of colors to indicate the
setting is saved and return to the Settings Mode.
There are 4 ring modes available: NPPL/Semi Auto, PSP/Burst, Millennium/Ramp,
and NXL Style Full Auto.
IMPORTANT: When the Firing Mode is changed it will also automatically modify
the corresponding Max Rate of Fire and ramping parameters that correspond to that
mode. These settings may be changed after Firing Mode is selected.
# of Blinks Mode
1 NPPL/Semi
2 PSP/Burst
3 Mill/Ramp
4 Full Auto
NPPL/Semi Auto: Marker will shoot 1 time for each time the trigger is pulled. The
default setting meets 2011 NPPL marker rules.
Default: Max ROF = 15.0bps
PSP/Burst: Marker will shoot in semi-auto mode equal to the number of shots
specified by the Ramp Start setting (see below for more information), then will go
into a 3-shot burst at the Max ROF setting. If the marker is not fired for 1 second, the
marker will shoot semi-auto until Ramp Start is again achieved. The default setting
meets 2011 PSP marker rules.
Default: Max ROF = 12.0bps; Ramp Start=3shots
Millennium/Ramping: Marker will shoot in semi-auto mode equal to the number of
shots specified by the Ramp Start setting, and if the Ramp Sustain ROF (see below for
more information) is achieved, the marker will ramp up to the Max ROF setting. If the
marker is not fired for 1 second the marker will shoot semi-auto until ramping
To Next Page
Loading...
