Page 13
3. TO CHECK THE OPERATION OF THE HYDROMASSAGE JET
SYSTEM IN SPA and to purge any remaining air from the system
complete the following steps:
• Press the jets buttons on spa side control panel placing all
hydromassage jets on.
• Once the jet system is fully operational (as indicated by strong,
non-surging jets), priming of the
spa side
is complete.
• To turn off the jets, press the jets
button on the spa side control
panel
.
• If you do not feel a steady stream of water from your jets, refer
to the instructions for priming the pump in the
fitness system
TROUBLESHOOTING section.
4. SET THE TEMPERATURE CONTROL to the desired temperature
between 15°C (59°F) and 40°C (104°F) on both the swim side and
the spa side control panels, then place the fitness system cover
on the fitness system and allow the water temperature to stabilize
approximately 0.5°C (1°F) per hour. Make sure you secure the cover
in place. Periodically check the fitness system water temperature.
When the water temperature reaches desired temperature, proceed
to the next step. The fitness system temperature is pre-programmed
to reach 29.5°C (85°F) on the swim side and 38.0°C (100°F) on the
spa side. You may change the water temperature by pressing the
button on each control panel to raise the temperature, or lower
temperature by pressing the ▼button.
5. USING A TEST STRIP AND APPLICABLE CHEMICALS adjust
Total Alkalinity (TA) to 80-120 ppm, Calcium Hardness (CH) to
50-150 ppm, then fitness system water pH to between 7.2 and 7.8.
These procedures are listed in the “Water Quality and Maintenance”
section.
OPERATION NOTE: Adjusting the Total Alkalinity as the first step
is important, as out-of balance TA will affect your ability to adjust the
pH correctly and will prevent the sanitizer from operating effectively.
IMPORTANT: Activate the swim machine by using the blue swim
machine remote and increase speed to at least 50% before adding
chemicals. Disperse the chemicals in the swim area away from the
walls.
6. SUPERCHLORINATE THE FITNESS SYSTEM WATER by adding
1½ teaspoons of chlorine (sodium dichlor) per 950 liters
(250 gallons) of water while running the swim machine above 50%
for 10 minutes in the swim side. Disperse the chemicals in the swim
area away from the walls. Add into filter area on the spa side while
running both jets for 10 minutes.
7. TEST THE FITNESS SYSTEM WATER FOR CHLORINE
RESIDUAL. If the residual is between 1 and 5 ppm on the test
strips, go on to the next step. If the residual is less than 1 ppm,
activate the swim machine (on swim side) above 50% for another
10 minutes and add more chlorine as needed, or if needed activate
the jets on the spa side and run both jets for 10 minutes.
WARNING: High sanitizer levels can cause discomfort to the user’s
eyes, lungs and skin. Always allow the sanitizer level to fall to the
recommended range before using the fitness system.
8. RECHECK the Total Alkalinity (TA) 80-120 ppm, Calcium Hardness
(CH) 50-150 ppm, and the pH must be between 7.2 and 7.8.
The
fitness system
is ready for use when the
fitness system
water
has circulated and the bromine level remains between 1 and 2 ppm
or chlorine level remains between 1 and 5 ppm.
Getting Started
To Next Page
Loading...
Need help?
General
