Page 14
operatInG InStructIonS
The fitness system has two control panels, one controls the large
swim side and the other controls the smaller spa side.
SWIM SIDE CONTROL PANEL
The swim side control panel provides a bright, full color display, and
intuitive user experience, while its screen’s high resolution brings
fitness
system
user interfaces to a new level. Loaded with a large amount of
memory and a powerful on-board processor creating seamless graphic
interface that
fitness system
users have been waiting for.
SWIM SIDE CONTROL PANEL
FUNCTIONS
When the screen is off, press any button to turn the control panel screen
on and display the home screen. After 30 minutes of inactivity the screen
will shut off.
The function description of the buttons below will only work from the
Home screen. Once the swim side control panel is placed in a submenu
the selection lights next to the buttons will light up to indicate which
buttons may be selected for a specific screen function.
SETTINGS
One press of the (Settings button) from the home page gives you
access to a menu to manage the settings of your
fitness system
where
you will find:
• Water care
• Audio (optional)
• Maintenance
• Date and time
• Keypad Settings
• Miscellaneous
• Electrical configuration
• Factory reset
• About
Use the or buttons to move up and down in the list. To select an
option, press the lit button beside the desired highlighted option.
IMPORTANT: At any point you can press the (Settings button) to
return to the home screen or (top left button) to go back.
WATER CARE / HEATER SETTINGS
The Water Care section will help you set
up your ideal heater settings in the swim
area. Choose from Away from Home,
Beginner, Energy Savings, Super Energy
Savings, and Weekender, depending on
your needs.
Use (middle left) button to choose
your setting. A green check mark will
appear on the selected icon to confirm.
When in Economy mode, the heating set point will be reduced by 11°C
(20°F), which means that the heating system will not come on during
the set time unless the temperature falls 11°C (20°F) below the fitness
system's set temperature.
Because the swim side uses a 24 hour circulation pump and there are no
other jet pumps used on the swim side the Purge Time is not applicable.
WATER CARE MODES
Away from home:
In this mode the swim side will always be in economy mode;
the set point will be reduced by 11°C (20°F).
Beginner:
The swim side will never be in economy mode.
Energy Savings:
The swim side will be in economy mode during the peak hours
of the day and resume normal mode on the weekend.
Super Energy:
The swim side will always be in economy mode during peak
hours, every day of the week.
Weekender:
The swim side will be in economy mode from Monday to
Friday, and will run normally on the weekend.
MODIFYING SCHEDULES
To modify a Water Care category, use
the (middle right) lit button, to
open the selected Water Care menu.
The menu screen is divided into two
settings, Economy and Filter cycle with
Economy being first. Set or change the
Day, Start and Stop time if desired to
keep the heater off (Economy mode).
Since there are no jet pumps used in the swim side there is No need to
make any adjustments to the Purge time.
You can add schedules by scrolling down to Add, and selecting by
using the (middle left) lit button.
To delete a highlighted schedule,
press (top right) lit button.
You can modify the schedules by
selecting (middle left) lit button
and adjusting the schedule using
the or buttons. Press
(middle left) lit button to move
between parameters.
Settings
Audio
Selection
Button
Selection Lights
Selection
Button
Selection Button
All Off/Memory On
Up/
Temperature
Down/
Temperature
External
Lights
Internal Lights
Operating Instructions
To Next Page
Loading...
Need help?
General
