Page 18
WATER CARE MODES
Away from home:
In this mode the spa side will always be in economy mode;
the set point will be reduced by 11°C (20°F).
Beginner:
The System will never be in economy mode and will be
filtering according to the pack's low level configuration.
Energy Savings:
The spa side will be in economy mode during the peak hours
of the day and resume normal mode on the weekend.
Super Energy:
The spa side will always be in economy mode during peak
hours, every day of the week.
Weekender:
The spa side will be in economy mode from Monday to Friday,
and will run normally on the weekend.
MODIFYING SCHEDULES
To modify a Water Care category, use
the (middle right) lit button, to open
the selected Water Care menu. The
menu screen is divided into two settings,
Economy and Filter cycle with Economy
being first. Set or change the Day, Start
and Stop time if desired to keep the
heater off (Economy mode). Scroll down
to set or change the Filter cycle Day, Start and Duration.
You can add schedules by scrolling down to Add, and selecting by
using the (middle left) lit button.
To delete a highlighted schedule,
press (top right) lit button.
You can modify the schedules by
selecting (middle left) lit button
and adjusting the schedule using
the or buttons. Press
(middle left) lit button to move
between parameters.
You have several possibilities for the schedule (Mon-Fri, weekend, every
day, or single days). The schedules will be repeated every week. Once
you have set the schedule, use (top left) lit button to go back.
Ensure that you have selected the desired Water Care option in the main
Water Care menu.
MAINTENANCE
From the Settings page you can
access the Maintenance menu,
which gives you access to the
following options:
• Maintenance reminders
• Standby
• Error log
Use the
or buttons to make a selection, and (middle left) lit
button to select.
MAINTENANCE REMINDERS
The control panel will remind you of
maintenance required on the spa
side, like rinsing or cleaning the
filter. Each task has its own duration,
based on normal use.
The Maintenance reminders menu
allows you to verify the time left
before maintenance is required, as
well as to reset the time once a task
is completed.
Use the
or buttons to move through the list.
To reset a task select it by pressing the (middle left) lit button, then
confirm by pressing the lit button next to confirm when prompted. Once
you have confirmed the task will be reset.
STANDBY
The Standby mode allows you to service
the spa side. Pumps will stop for 30
minutes, and automatically restart after
this time. Press (middle left) lit
button to activate Standby mode.
Once Standby mode has been activated
a screen will appear to show that pumps
are stopped. The normal page will
return at the end of maintenance.
Press on the button next to cancel to leave Standby mode and restart
the spa side.
ERROR LOG
In this section you can see errors
that have been archived by the
system. Use the or buttons
to move through the list. Errors are
archived chronologically, from most
recent to oldest (top to bottom).
The Error log page shows the error
code, the date of the error, and the
time. To see more details on an
error select it with (middle left) lit button. A screen will appear with
more information on the selected error.
For more information, see the Error messages section. To clear the Error
a Factory Reset is required.
DATE AND TIME
Here you can adjust the time
format, change the year, date, and
time. Use the or buttons to
choose the setting that you want to
adjust, and select it by pressing
(middle left) lit button.
Use the or buttons to
change the parameters, and
(middle left) lit button to move
between parameters. Press (top left) lit button to take you back to
the main Settings menu.
Operating Instructions
To Next Page
Loading...
Need help?
General
