Endress+Hauser Cleanfit CPA871 - Page 28

Mounting Cleanfit CPA871
28 Endress+Hauser
Assembly connection PN16
Delivery
Rinse connections vary depending on the connection selected (G¼", NPT¼" or Swagelok)
Connections Thread Delivery
Dummy plug M16, male thread Mounted
Pressure retarder M16, male thread to M16 female
thread
Mounted
Rinse connection outlet G¼" or NPT 1/4", female thread, or
pipe connection
Mounted on pressure retarder
Rinse connection inlet G¼" or NPT 1/4", female thread, or
pipe connection
Included
Changing the dummy plug/rinse connection inlet
If an (automatic) cleaning or calibration system is used, the dummy plug must be replaced
with the accompanying rinse connection inlet. The inlet and outlet must be fully connected.
1.
A0043258
Remove the dummy plug.
2. Replace the flat seal with the O-ring.
3.
A0047539
Screw in the rinse connection inlet.