Operation Deltabar M 4...20 mA HART
12 Endress+Hauser
4.2.2 Structure of the operating menu
User role Submenu Meaning/use
Operator Language Only consists of the "Language" parameter (000) where the operating language for the device
is specified.
The language can always be changed even if the device is locked.
Operator Display/operat. Contains parameters that are needed to configure the measured value display (selecting the
values displayed, display format, display contrast, etc.).
With this submenu, users can change the measured value display without affecting the actual
measurement.
Service
engineer/
technician
Setup Contains all the parameters that are needed to commission measuring operations. This
submenu has the following structure:
• Standard setup parameters
A wide range of parameters, which can be used to configure a typical application, is
available at the start. The measuring mode selected determines which parameters are
available.
After making settings for all these parameters, the measuring operation should be
completely configured in the majority of cases.
• "Extended setup" submenu
The "Setup" submenu contains additional parameters for more in-depth configuration of
the measurement operation to convert the measured value and to scale the output signal.
This menu is split into additional submenus depending on the measuring mode selected.
Service
engineer/
technician
Diagnosis Contains all the parameters that are needed to detect and analyze operating errors. This
submenu has the following structure:
• Diagnostic list
Contains up to 10 error messages currently pending.
• Event logbook
Contains the last 10 error messages (no longer pending).
• Instrument info
Contains information on the device identification.
• Measured values
Contains all the current measured values
• Simulation
Is used to simulate pressure, level, flow, current and alarm/warning.
• Reset
Expert Expert Contains all the parameters of the device (including those in one of the submenus). The
"Expert" submenu is structured by the function blocks of the device. It thus contains the
following submenus:
• System
Contains all the device parameters that neither affect measurement nor integration into a
distributed control system.
• Measurement
Contains all the parameters for configuring the measurement.
• Output
Contains all the parameters for configuring the current output.
• Communication
Contains all the parameters for configuring the HART interface.
• Application
Contains all the parameters for configuring the functions that go beyond the actual
measurement (e.g. totalizer).
• Diagnosis
Contains all the parameters that are needed to detect and analyze operating errors.
To Next Page
Loading...
