Endress+Hauser Deltabar S - Operating Elements

Operation Deltabar S PROFIBUS PA
20 Endress+Hauser
6.2 Operating elements
6.2.1 Position of operating elements
With regard to aluminium housings (T14/T15) and stainless steel housing (T14), the operating
key is located either outside the device under the protection cap or inside on the electronic
insert. In hygenic stainless housings (T17), the operating key is always located inside on the
electronic insert. Additionally, three operating keys are located on the optional on-site display.
P01-xMD7xxxx-19-xx-xx-xx-074
Fig. 7: Operating key external, under the protective flap
1 Operating key for position adjustment (zero point
correction) and total reset
P01-xxxxxxxx-19-xx-xx-xx-105
Fig. 8: Operating key and operating elements, internal
1 Green LED to indicate value is accepted
2 Operating key for position adjustment
(zero point-correction) or total reset
3 DIP switch for hardware address
4 Slot for optional display
5 Slot for optional HistoROM
®
/M-DAT
6 DIP-switch for locking/unlocking
measured-value-relevant parameters
7 DIP-switch for damping on/off
➀
0%
Zero
Display
Sensor
on
off
0%
Zero
Address
SW
HW
1 2
3
4
5
678
on
off
Histo
ROM
on
off
➀➁
➂
➃
➄
➆➅
t
PC
21
21
CKON
3 4 5678
S D A0 8