Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus Parameter description (FF configuration program)
Endress+Hauser 47
Device Dialog/
DEVICE DIALOG
Display
Index: 42
Data type: unsigned8
Access: read only
If configuration is unsuitable, this parameter displays a message indicating that a
configuration error is present. The message can also refer to the parameter that was
configured incorrectly.
Insert Pin No/SW_LOCK
Entry
Index: 43
Data type: unsigned16
Access: auto, OOS
For entering a code to lock or unlock operation.
!
Note!
• The -symbol on the local operation indicates that operation is locked. Parameters
which refer to how the display appears, e.g. Language/DISPLAY_LANGUAGE and Display
Contrast/DISPLAY_CONTRAST, can still be altered.
• If operation is locked by means of the DIP switch, you can only unlock operation again by
means of the DIP switch. If operation is locked by means of remote operation, you can
only unlock operation again using remote operation.
→ See also Operating Instructions BA00301P (Deltabar S) or BA00302P (Cerabar S) or
BA00372P (Deltapilot S), "Locking/unlocking operation" section.
Options:
• Lock: Enter a number between 0 and 9999 and ≠100.
• Unlock: Enter the number 100.
Factory setting:
100
Status Locking/
STATUS_LOCKING
Index: 44
Data type: UNSIGNED8
Access:
Displays the current locking status of the device or conditions that can lock the device
(hardware locking, software locking).
Hardware Rev./
HARDWARE_REVISION
Display
Index: 45
Data type: visible string
Access: read only
Displays the revision number of the main electronics e.g. V01.00
Electr. Serial No./
ELECTRONIC _SERIAL
_NUMBER
Display
Index: 46
Data type: float
Access: read only
Displays the serial number of the main electronics (11 alphanumeric characters).
Proc. Conn. Type/
PROCESS_CONNEC-
TION_TYPE
Selection
Index: 47
Data type: unsigned16
Access: auto, OOS
For selecting and displaying the process connection type.
Options:
•Not used
•Unknown
• Special
•Oval flange
•Thread female
•Thread male
•Flange
•Remote seal
Resource Block
Parameter Description
To Next Page
Loading...
